Can you install recessed lighting finished ceiling

The amount of space between each light is determined by the result. For an 8-foot high ceiling, the spacing between the lights would be 4 feet. Good spacing for general room lighting can be provided by this.

There are a lot of holes that are the same size. To protect the lights, the holes must be cut to a precise size and sealed. Each installation takes between 2 and 2. The flexibility to change the finishes later is one of the main reasons why the lighting is timeless. The can is in the ceiling. The finish can be bought in a variety of colors and styles to fit your needs. You have the ability to change them as you please. Contents Do you need an electrician to install recessed lighting?

Can I install my own recessed lighting? What is the difference between can lights and recessed lights? How do you install recessed lights? How hard is it to install recessed lighting? How much does it cost for an electrician to install recessed lighting? Is recessed lighting outdated? We use cookies on our website to give you the most relevant experience by remembering your preferences and repeat visits. However, you may visit "Cookie Settings" to provide a controlled consent.

Cookie Settings Accept All. Manage consent. Close Privacy Overview This website uses cookies to improve your experience while you navigate through the website. Out of these, the cookies that are categorized as necessary are stored on your browser as they are essential for the working of basic functionalities of the website.

We also use third-party cookies that help us analyze and understand how you use this website. These cookies will be stored in your browser only with your consent. You also have the option to opt-out of these cookies. But opting out of some of these cookies may affect your browsing experience. Locate the ceiling joists on either side of the desired locations for each of the recessed lights using a stud finder.

Enter the attic above the room and locate each of the pilot holes. Pull back any insulation to clear the area around each location.

Center a recessed light can over each of the holes, including the original light fixture hole, and draw the perimeter of the cutout around the can onto the drywall. Cut out each drywall hole using a keyhole saw. Remount the junction box with the electrical cable from the light switch onto the top of one of the ceiling joists using the mounting screws you removed to loosen the box earlier.

Secure the wiring along the ceiling joists with wire staples using a hammer. Cut the cable from the roll with a pair of wire cutters, and feed 12 inches of one end of the cable through the drywall hole and 12 inches on the other end into the junction box.

Run a separate section of cable between the junction box and each additional drywall hole. Tighten the wire clamps to secure the wires to the junction box with a screwdriver. Remove the outer sheathing from each cable with a utility knife. Connect all of the black wires together with a wire nut, followed by the white wires and then the bare wires. Tuck all of the wires into the junction box and install a junction box cover to protect the wiring.

Return to the room below, and remove the cover of the wiring compartment of a recessed light. Insert the end of one of the cables into the wire clamp of a recessed light can. Tighten the screws to secure the cable within the clamp, then remove the outer sheathing from the cable with a utility knife.

Connect the white wires in similar fashion, then connect the bare wire to the grounding screw with a screwdriver. Push the wires into the wiring compartment and replace the compartment cover.

Push the wires up into the hole in the ceiling and slide the recessed light can into the hole until the flange on the bottom edge is flush with the ceiling.

Fold out the four mounting clip tabs within the can so that they hold the can in place against the drywall.